Jump to content


  • Content Count

  • Joined

  • Last visited

About Lewisdorling@hotmail.com

  • Rank

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I’ve got a s6 one g4+ rx7 Ecu. The s7 have extra analog pin out 7,8 and 9 I need two extra inputs. Ive been told there available but not what pin. Can you tell me the pin on the upper board that corresponds to these outputs so I can add them into my s6. Thanks
  2. I’m trying to gain analong inputs for egt sensors. I was informed this box would give me extra inputs. Would it just be a case of re pinning the can wires into the rs pins ? thanks
  3. Hi I’m trying to connect an ecu master can expanded into can l and h on the ecu board. However I’m having trouble. This is the pin out of the module I’ve wired the +5 and ground, then can h and l into the ecu is this correct ? thanks for your help
  4. I’m just wirreing in an aem water injection kit, I want to know where the green and yellow wires go ? (Arm switch and boost safe). I’m also using aem coils and want to wire them in direct fire, where should I take the extra wire needed from for the remaining coil? Thanks
  • Create New...