Jump to content

Search the Community

Showing results for tags 'aim dash'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Link
    • G4+
    • G4
  • Vi-PEC
    • Vi-PEC i Series
    • ViPEC V Series
    • ViPEC Power Sport
  • General Topics
    • Guest
    • WishList
    • Engine Tuning
    • Customers Vehicles
  • Historic Products
    • Link G2 G3
    • Link G1

Calendars

There are no results to display.

Blogs

  • Bryan
  • 카지노 사이트, 카지노 추천«TSG79.COM
  • 2JZ Tuning Tips

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. redmist

    AIM Dash, VIPEC CAN_BUS_FULL.LCC

    I'm attempting to get AT4 to display on my AIM EVO4 with my G4+ Xtreme. Unfortunately Race Studio is rather restrictive in terms of what it will display and the Generic Dash CAN configuration will not output AV4 unless I configure it as either OIL Temp or IAT. Both of which I'm also displaying. I noted that the VIPEC configuration for race studio includes a download for CAN_BUS_FULL.LCC.This is compatible with the early VIPEC software however I cannot read the frame layout in said version, so I can't manually copy it across to PCLink to configure my G4+. I wondered if there was a document displaying the frame layout for the VIPEC_CAN_Bus_FULL.LCC or conversion software that can copy the LCC into LCS format? Cheers, Daniel.
  2. noodle

    CAN Link G4+ to Aim MXL Strada

    Hi All, After 8 months of my STi being off the road - finally got it back running a whole lot of new gear (Thanks to Matt Ashley for the Tune). Including the Link G4+. Prior to this I was running another ECU (Aut****) that connected the RS232+, RS232- and negative to an aux jack which went into the ECU. Now that I have the Link G4+ it has a separate CAN/RS232 pin out which you need an adapter for (purchased both CAN/RS232 ECU Adapter, Spare CAN plug and connected both). I have connected/wired the CAN H and CAN L to the AIM CAN + (to H) and CAN - (to L) as per instructions. Set the protocol up (as per AIM instructions) on Software/Link ECU (CAN SETUP) and Race Studio 2. Now - everything on Race Studio seems to be reading correctly after setting it up as a new 'profile'. However, once car is running - data is not being transferred (RPM/Gear/etc). How would I go about this? I'm going to attempt again tonight and re-check solder/wires etc. Regards, Nick.
×