Search the Community
Showing results for tags 'aim strada'.
Found 1 result
Hoping i could get some clarification on the following, currently in the process of wiring a g4+ fury, aim strada 1.2 dash and LS1 coils 1st query is on the signal ground for the LS1 coils, can i wire the signal ground and the power ground both to the engine block? as per picture? Not sure if the sensor ground is required to pass back into the ecu 2nd query is on the aim strada can wiring on the aim wiring i have can 1+ and can 1-, can i wire these into can 2 l and can 2 h on the b plug and program to talk with the can setup in g4+ software? i figured this was easier than getting the correct plug for the link to wire into can1? 3rd query the 5v supply for generally sensors is there a limitation to how many sensors you can run off this 5v supply? i've noted from factory it is spliced into 2 wires, if i run 10 sensors that require 5v feed for example do i just splice this 5v feed 10 times? Does the same go for the green sensor ground wire and seeing as A/B plug each have their own grounds are the sensors required to be grounded relative to the plug they came from? New to using link and wanted to confirm rather than assume Appreciate any assistance