Search the Community
Showing results for tags 'controller'.
Found 3 results
Hi Guys, i have a 2JZ-GTE swapped Altezza running a Link G4+ Fury and i am looking to run an MR2 electric power steering pump. i have talked to my certifier and he will not allow it to be directly plugged into a power supply as it must go through a 'controller' so that the pump is in a 'controlled environment'. which after some reading is it possible to use my Fury to control this in any way? obviously my gearbox speed sensor is plugged into the ecu aswell as my seperate sensors on my wheels, would the link fury pick this up and be able to control the pump? hopefully this helps. Cheers Mike
Hey guys, im fairly new to the turbo game and I just bought a G4+ Plugin (Being shipped as I type) and I had a couple of questions I was hoping someone could answer for me. Id like to use the Electronic boost controller function of the G4+, Just not entirely sure what I need to buy on top of the ECU, would a new boost solenoid be essential? In cabin adjustment would be great! Would I also benefit from a wide-band 02 Sensor? or is there a more reliable sensor setup I could integrate with the G4+? Cheers again for the help, Dane
Hi I'm using Fury and I am controlling LSU4.9 BOSCH lambda sensor with fury internal lambda sensor controller. I have connected the cables completely as same as the instructions in the Online Help. But I'm receiving these errors. Do you have any suggestions? One thing that I'm worried about is, I'm using +14V(A connector pin 5) as the Ignition +12V input(LSU 4.9 pin 4). I read the instructions of the LSU 4.9 and it says. "Power supply H+ nominal 7.5 V" "System supply voltage 10.8 V to 16.5 V" I don't have 12V output in my ECU so I can only use +14V cable or the +8V cable on the A connector of my Fury ECU. Am I doing some thing wrong or any suggestions would be very helpful. Thank you.(^^♪ http://www.bosch-motorsport.de/media/catalog_resources/Lambda_Sensor_LSU_49_Datasheet_51_en_2779147659pdf.pdf