Search the Community
Showing results for tags 'e-trottle'.
Found 2 results
Hello Guys, ECU Thunder, Evo 8 4g63 engine with DBW conversion (Evo X pedal + Bosch 68mm E-Throttle) I set the deadband to 0.0% (0.1% at idle is not acceptable ) The ecu can't reach the TP% requested.... For example... in the e-Throttle 1 table at 0% AP...i set 3% TP... Then idle position set to 0.3%... In some cases the ecu set TP to 3.4% (+0.1% that requested) other times 3.2% (-0.1% that requested) sometimes 3.3% (as requested) but need much time to reach that TP%... My dbw settings are : - P = 9 - I = 0.145 - D = 35 Any advice ? Thanks Regards
Hi dear developers! Yesterda, pondering the next two projects I realized that i do not have a map for the implementation of all ideas. More precisely, i can cope with the fact that there is in the current version of the software, but if i do everything as relies, i need another Map. Soo i have a e-throttle and EGT sensor. 4D fuel map is active and it's adjust the AFR of EGT sensor - good , but thats not all. So i want to Link-ecu is limit the e-throttle to 15-20%. For the realization that i can adjust the e-thettle map 3 wich will depend of the EGT sensor voltage, BUT i think it's will be realizate in another map... I would suggest to create a new map in section "Engine protections" > e-throttle limit > 3d map of e-throttle opening by INPUT (anVolt may be) . This will save the engine when EGT will be so high (fuel pump failure) . Can you add a map? Thanks in advance for your reply.