Search the Community
Showing results for tags 'ej20'.
Found 2 results
I have 2012 JDM Subar WRX STI Spec.C (Ver 11 I guess...) Engine : EJ207 quad AVCS I have setup all the VVT stuffs. Including Camshaft position sensor's offset using the cam angle test. I took a log and it describes that, intake cams are correctly at the target position. But Exaust cam pos is hunching(going up and down around the target cam position) I have both tried cam control mode as SUBARU Quad AVCS and SUBARU AVCS EJ20. Both of them had the same result. I have my Link Fury as Piggybacked to my OEM ECU. But I have disconnected all the cam position sensors, cam solenoids etc.. from the OEM ECU. Does anyone have any guesses? Log 2018-04-19 1;31;19 am.zip G4+Fury-initial51.pclr
Hello Thank you for your attention. I need help with my Subaru WRX STI 2011 JDM EJ207. I have implemented my Link G4+ fury with my car. But my engine does not increase rpm more than 5500rpm. Under 5000 rpm works fine. I've tried changing my ignition timing from 45 BTDC to 0 BTDC but it does not have any effects. I've also double checked my dwell table, Ignition delay, Ignition charge time as same as shown in help in PCLink that it's same as the EJ20 quad AVCS configuration. Do you have any guesses? Thank you very much.