Search the Community
Showing results for tags 'idle control'.
Hi Everyone. I am experiencing some trouble with my ignition setup on my M50B29 Vanos engine with Link G4 with V4.10.2 firmware from 2014. Background: The car was initially built in 2011 with a M50B28 non vanos engine with pretty sporty cat cams and have been working fine until I totally rebuilt the engine to a hybrid M50B29 with a vanos unit mounted on an non vanos head to get 7mm valve shafts. head also have dual intake cams from M54 and M50, M54 on intake and M50 on exhaust. This to make the engine a little more calm on low revs. I experienced some troubles with the previous set
Hello! I´ve been having issues with my idle on my 4g63 (eclipse 1993) So I´ve been working with the ISC on closed loop, I have the RPM lockout higher than my targets and for the most part it seems fine however every once in a while it falls under 800rpm and normally stalls if I dont hit the gas pedal, I´ve changed all the setting the AFR is stable doesnt fluctuate however it always seems to have the same problem. the logs are atatched the stall is almost at the end idle stall.llg
As the title, i installed a link g4 plugin on a completely stock 3SGE and set up the throttle sensors for the ethrottle. I am using the stock MAF on the basemap included in the tuning software. The throttle sensors and MAF sensors make logical sense, which has got me confused as to why the car wont idle. It will start up, and can rev a little bit, but when you get off the accelerator, the car stalls. Tune file attached. Any help would be appreciated. Thanks. 002 system.pclr