Search the Community
Showing results for tags 'mini cooper'.
Found 2 results
Just wondering how the launch control function works on the mini, I had seen the setting in the ecu and thought it might be handy in my mini challenge race car...my car has no ABS which means no t/c either. The one main thing I want to know is how does the car know when to go into launch and when not to?
c0op3r posted a topic in Vi-PEC i SeriesScott I have been watching the YouTube Videos for setting up the I88 G+ using the Link software, you make mention of having the correct data for the Injectors. I have not been able to find the data on my injectors: Siemens / Deka 04891574AB the data I have is as follows: Siemens DEKA 46lb/hour with EV6 / USCAR Connector - Direct fit for SRT , LS2 & LS7 Siemens DEKA High Impedance Injectors These injectors flow 46.5 lbs/hr at 43.5 PSI ( 3 BAR ) and much more at higher PSI! In addition, these units are high-impedance. Despite the high flow rate, they are linear and controllable at low pulse widths and have been used in ULEV applications! This allows you to use a larger injector than normally possible without hurting idle and low speed driveability. Adding to the flexibility of application, these units are high-impedance; making them compatible with most ECUs, while delivering the most flow available in a High-Impedance injector. These injectors represent the most current Siemens DEKA engineering and are used on many high power turbo and supercharged oem applications. These injectors are able to function at high fuel pressures and don’t exhibit the high fuel pressure handling problems found with many other high flow high-impedance injectors. This makes these injectors very well suited to turbocharged and supercharged applications that see high fuel system pressures and in fact, that is exactly what they were designed for! Engine performance and running quality are enhanced through the optimized spray pattern. Unlike competitors “pencil stream” high flow injectors; these High Flow injectors utilize a multi-orifice tip for improved mixture preparation and atomization. This results in lower BSFC and better idle quality than many injectors with less flow. Features: Genuine, reliable Siemens InjectorsExcellent response characteristicsRobust DesignHigh ImpedanceLow Impedance performance characteristics with High Impedance CompatibilitySpecifications: Coil Resistance: 12 Ohms (This high-impedance injector will work with all factory ECM/PCM injector drivers)Gain: 0.75Spray Pattern: ConeElectrical Connector: USCAR (New-style V=EV6 / Oval / LS2)Fitted with Viton upper and lower o-rings.Static Flow Rate @ 43.5PSI (300kPa): 46.5 lb/hr = 5.86g/s = 478cc/min (+/-3%)Static Flow Rate @ 58.0PSI (400kPa): 53.7 lb/hr = 6.77g/s = 552cc/min (+/-3%)Dynamic Flow Rate 2.5ms PW @ 100Hz (400kPa): 11.42mg/pulse +/-4%But I dont think I am getting all the information that the ECU wants to get the most from the setup, can you help with the information that the Link Software wants? Cooper