Search the Community
Showing results for tags 'mister3'.
Found 3 results
unable to configure my aem uego wideband with my link g4+ as i have mentioned this problem in my previous post . this is how it is at the moment wideband configure as analog volt 5 as wideband function lambda 1 calibration cal table 4 low volt is 0.00 high volt is 5.0 error value value 34.464 lambda Cal table is input value A 0.00v input value B 4.25V output units Lambda output value A 0.683 output Value B 1.264 what am i doing wrong its not showing as my aem wideband showing afrs
hello to all link forum members i need some help regarding setting up my fic 1450 low impedance fuel injectors in the application toyota 3sgte st205 with link g4+ i do not have the injector data because i found these injectors used ones i need injector dead time table and the short pulse adder table to run the car properly. i already have the injector resistor pack for low impedance injector. any help will be highly appreciated . thank you all in advance attached the injector picture below .