Search the Community
Showing results for tags 'my05 sti'.
Found 1 result
G'day, Looking at wiring up my Australian MY05 STI and want to confirm a couple of things before I commit. I have a WRXLINK V7-9 and am adding IAT sensor, fuel pressure sensor, oil pressure sensor and converting to E-throttle. Looking to use the two expansion connectors and this is my plan: Connector 1 - AN Temp 4 - Intake Air Temp sensor (Link IAT 1-8) AN Volt 11 - Fuel Pressure Sensor (AEM 150 PSI stainless steel) Connector 2 - E-throttle set up is from a MY13 STI. Gnd - All sensor and E-throttle grounds +5V Out - All sensor and E-throttle 5V AUX 9 - Throttle 12V+ Aux 10 - Throttle 12V- Volt 6 - Throttle Sensor 1 Volt 7 - Throttle Sensor 2 Volt 9 - Pedal Sensor 1 Volt 10 - Pedal Sensor 2 I still have no where to connect the Oil pressure Sensor, can the IGN pins on connector 1 be re-assigned? or should I look at connecting to the main header? I will also be running a LINK Can Lambda and flex fuel sensor. There is a note in the instructions not to overload the 5V output. How much is too much? I will have the E-throttle, IAT, Fuel and Oil Sensors.