Jump to content

Search the Community

Showing results for tags 'r33 rb25det'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Link
    • G4+
    • G4
  • Vi-PEC
    • Vi-PEC i Series
    • ViPEC V Series
    • ViPEC Power Sport
  • General Topics
    • Guest
    • WishList
    • Engine Tuning
    • Customers Vehicles
  • Historic Products
    • Link G2 G3
    • Link G1

Calendars

There are no results to display.

Blogs

  • Bryan
  • 카지노 사이트, 카지노 추천«TSG79.COM
  • 2JZ Tuning Tips

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests


ECU model


Serial Number


ECU model

Found 2 results

  1. Hi I've just finally got my Skyline on the road which has a Link G4 Storm ECU I have a Windows 10 Tablet mounted and I can autostart the app to run when the tablet is booted but is there an "autoconnect" to the ECU? Rather than having to press F3? Thanks in advance!
  2. Hi All, Recently had my Link G4+ PnP installed & setup on my 1997 R33 GTST Series2 w/RB25DET, based in Ireland Last night out of nowhere, my EML started to flash in a sequence then I lost all power & had to get the car recovered home :-( Hooked up the notebook to it this morning and the car started fine(typical) but the Link software was showing the following errors ECU Fault Code 26: An volt 6 below Error Low value ECU Fault Code 74: Analog 5v Supply Error An6 - NB Oxy(V) = 0.74 going up to 0.82 Now, I have been having intermittent lumpy running below 3.5K since the Link ECU was installed a few months back but we have a innovate wideband on the way. At a guess those codes refer to the narrowband lambda sensor? Link ECU Fault Code 26 & 74 https://www.youtube.com/watch?v=Pk_wCCydLEY EML sequence Will be contacting the tuner later but looking to learn something here Thanks in advance
×
×
  • Create New...