Jump to content

Search the Community

Showing results for tags 'speed'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Link
    • G4+
    • G4
  • Vi-PEC
    • Vi-PEC i Series
    • ViPEC V Series
    • ViPEC Power Sport
  • General Topics
    • Guest
    • WishList
    • Engine Tuning
    • Customers Vehicles
  • Historic Products
    • Link G2 G3
    • Link G1

Calendars

There are no results to display.

Blogs

  • Bryan
  • 카지노 사이트, 카지노 추천«TSG79.COM

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. sama

    Help with can setup

    Hi everybody, sorry I didn't provide serial number but I don't have the number near, I will edit such information tomorrow. i have just installed a G4+ on a Toyota Celica built for circuit racing and the car has the Bosch Motorsports ABS system which has the ability to share some information via CAN, I need to setup the 4 wheel speed to be able to start playing with the both the boost by speed and at the same time with traction control, I got some help with the people over at Bosch and got this information, I will be trying to set it up tomorrow, but they ask me something that I don't have a clue as this is my first time setting up a Link ecu. This is what I got: Stream 1 -> single frame only: "add parameters" for a total of four parameters: Parameter = LF Wheel Speed Start position = 0 Width = 16 Byte order = LS First Type = Unsigned Multiplier = 45 Divider = 8 Offset = 0 Parameter = RF Wheel Speed Start position = 16 width/byte/type/multiplier/divider/offset = same as above Parameter = LR Wheel Speed Start position = 32 width/byte/type/multiplier/divider/offset = same as above Parameter = RR Wheel Speed Start position = 48 width/byte/type/multiplier/divider/offset = same as above If you have a problem with the units translating incorrectly, it's most likely because of the multiplier and divider. I don't know what the Link ECU uses for units - m/s, km/h, km/min, etc... You might have to check with Link for the unit translation. Thanks all for your help! Sama
  2. Lobezy

    S15 G4+ plug-in speed sensor

    Hi There, I am trying to log my ADM S15's vehicle speed using the ECU logging, however when i use the LR wheel speed (DI5) sensor input it comes up with 0. My speedo and everything works with no issues but it seems as though the ECU cannot read my vehicle speed? I have also tried logging using the laptop reading every sensor and all of the listed vehicle speed sensors had no readings. Any suggestions? as this limits some of the gear specific mapping and traction control functions i'd like to look into. Cheers
×