Jump to content

Search the Community

Showing results for tags 'time'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Link
    • G4+
    • G4
  • Vi-PEC
    • Vi-PEC i Series
    • ViPEC V Series
    • ViPEC Power Sport
  • General Topics
    • Guest
    • WishList
    • Engine Tuning
    • Customers Vehicles
  • Historic Products
    • Link G2 G3
    • Link G1


There are no results to display.


  • Bryan
  • 카지노 사이트, 카지노 추천«TSG79.COM

Found 1 result

  1. I've modified My Evo to run sequential [direct] spark with a set of 4x Denso 90919-02229 coil packs from a 1L Toyota Yaris, but I can't find any information on the dwell times to adjust the 3D table. I am GUESSING that the Toyota Altezza (IS200 in UK) will be the same, or near as? If anyone's interested, hardwiring the mod was simple enough, just 2 extra wires from the triggers to coils 3 and 4 back into the cabin (i also used an extra 2 pin plug in line to make removal of the coils easier), remove the Fuel pump and BOTH A/C fan wires. Then pop the new wires into their place, move the High speed A/C and fuel pump wires to Ign 6 and 7 with the low speed A/C fan taped up out of the way. Then a quick change in PCLink to change Ign 3 and 4 to 'IGNITION' (or it won't display correctly when you change the mode from 'wasted' to 'direct' spark), then program 6 and 7 for the fuel pump and engine fan 3 respectively. Under 'ignition main' change 'wasted' to 'direct' [a.k.a sequential] spark and she's a runner! The last job will be adjusting the above table...... followed by reconfirming the base timing if my light will pick up the coilpack. If someone could post up the data sheet for the above, it would be really appreciated!