razzmtazz Posted June 22, 2019 Report Share Posted June 22, 2019 Hi I am in a process of wiring a strom black wire inn to a 2jzgte vvt have two problems at the moment one there is no start up calibration in the base maps for the 2jz vvt an other is there seems to be no idle control valve how to control idle? Thanks Quote Link to comment Share on other sites More sharing options...
Richard Hill Posted June 22, 2019 Report Share Posted June 22, 2019 You could use The Toyota supra map as a start, it's for a 1jz so not a million miles away. Check ignition settings wasted vs direct. I'm guessing your engine was e throttle which would have controlled the idle and has been converted to manual. You will need to set the base screw on the main throttle to give you cold idle, and then set up the idle ignition table. It can be a bit tricky to get good idles at cold and hot without an ISCV but it is doable. You'll probably need to bit a bit more aggressive with the values in the idle table. Add 2 lines to the idle table. One for cold and one for hot, these will then give you the span of engine temperatures. HTH Richard. Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 22, 2019 Report Share Posted June 22, 2019 Here is one to get you somewhere close. 2JZ-VVTi Start up.pclr Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.