Jump to content
Fotis

CoP

Recommended Posts

image.thumb.png.9c7e61363152bebf6c0ddd4f321304dc.png\

Looks like i am very unlucky but whatever. So rpm bounces up and down. This happens with load only . No trigger errors , scope looks good , timing locked , both signal ok.

Maybe bad coils ?

Share this post


Link to post
Share on other sites

I dont see many clues to where the problem is, it appears to be a misfire.  Can you try increasing dwell to about 2.0 and give it about 25deg timing and see if it changes anything.  I assume you have changed some stuff in the attached map compared to the log as the log shows 19deg timing @ 6000 but the map shows 24deg.  

Do something like this just for a test:

BZeT05W.png

 

2koG8HX.png

Share this post


Link to post
Share on other sites

Can you check the signal with the trigger pullups turned off in the ECU. As the signal is showing a 12V wave which would indicate there is a pullup in the AEM CAS unit. Then save a trigger capture as a log and attach.

Share this post


Link to post
Share on other sites

If there are multi pullups the switching of the signal might not be as clean and causing issues. In that image you can see the signal is starting to look a bit ugly already.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...