Jump to content
powerboy

Pull down Analog Input of Fury

Recommended Posts

I try to apply analog input to special condition (brake pressure sensor and DBW safety condition). 
I need to create possibility fault protection by Virtual Aux, ex An volt 1 < 0.5  or An volt 1 > 4.5.
I test the condition by putting  an on-off switch in line of An volt 1.
Noticeably, after cut off the switch of An volt 1, voltage of An volt 1 swings so long time and not below than 0.5.

I wound like to ask your help about external pull down resistor.
Is 100K or 1 M ohm ok for Fury without trouble to ECU and the sensor?
I knows output impedance of the brake sensor but i don't known input impedance of Analog channels.

Regards

Share this post


Link to post
Share on other sites

The max pulldown resistance you can use would be determined by the sensor rather than the ECU.  100Kohm should be fine for most common automotive sensors though.

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...