Jump to content
Sign in to follow this  
Davidv

Preventing E-throttle gear breakage Beams 3SGE (and similar)

Recommended Posts

Hi, 

On the default settings I've broken a few sets of E-throttle gears, and I've seen a few other people mention similar. 

(I've busted 3-4 gears already)

So I've been looking at ways to mitigate this. 
Initially I started just looking at the throttle mapping itself, setting the max and min to 2% and 98% so it's not trying to bang into the end stops.
But then realized that the e-throttle clutch can be used to help as well, by softening the clutch near the end stops. 

So I'm using a table like this, and havent had any breaks since: 

125906741_ethrottlegearssettings.PNG.a1facad66cb7f968e9daed57e3dc4dbe.PNG

1625975926_ethrottlegearssettings2.PNG.4cd01785756c37213dd7901eee57f50c.PNG


Perhaps it might need fine tuning on an individual basis to make sure it's not slipping too much near the extremities, but it's tested as working well tracking to its target even with high motor DC / fast accel/decel rates.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...