StijnFSP 1 Report post Posted September 11 Hi is there a way to build in a lean on load safety feature? Ir what axis should i use on a gprevlimit? Best regards Quote Share this post Link to post Share on other sites
Leiden 8 Report post Posted September 11 You could use the GP Rev Limit table with AFR Target on one axis and Lambda 1 on the other axis. You'd obviously want to have the Target Table filled out and have the Fuel Table close to where you want it, or on the rich side Quote Share this post Link to post Share on other sites
Adamw 586 Report post Posted September 12 Most tunes I see with this type of safety set up have MAP or MGP on one axis and Lambda on the other. That way you can set it up so it only comes into play under high load/boost and you dont have to worry about things like lean over-run etc causing a limiter. Quote Share this post Link to post Share on other sites
StijnFSP 1 Report post Posted September 17 Ok thnx was thinking of setting it up like that thnx Quote Share this post Link to post Share on other sites