Jump to content
Focos wrc

Fury with toucan and starada 1.2

Recommended Posts

Hi

I have a fury on order along with a aim strada 1.2.

 

Will I be able to use the toucan along with the strada on the ECU ok? I see it has 2 x canbus so have assumed it would.

 

Many thanks

(Will prob need assistance once it arrives getting it all to work)

Share this post


Link to post
Share on other sites

Yes, you can just connect them both to the same CAN bus.  Both use the same 1Mbit speed by default, AIM use a CAN ID of 1000 by default and the Toucan uses 1500 & 1501 by default so they will be all be happy together.

 

Share this post


Link to post
Share on other sites

Well all bits have arrived other than my loom at present 

 

Just few more questions about above 

 

I plan to wire the aim dash to can2 connections.

 

How would I connect the toucan and  be able to have the control via it without causing other issues.

 

Read about problems having the 6 pin plug connected for the toucan and trying to use tuning cable at same time....

 

Is there a way to connect the toucan hard wired and still be able to use all its functions? 

 

Many thanks again

Share this post


Link to post
Share on other sites

The coms issues come about when the TX and RX for the serial coms are connected to unused wires. 

If you wire in to the ECU on CAN 1 then use a CANF connector to wire to and only use CAN L and H and you will be fine. On CAN 2 there is no risk at all to effecting the USB coms.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...