Bculp7 Posted November 3, 2019 Report Share Posted November 3, 2019 Hooked up the aem wideband to an volt 6 works properly with the lambda but on start up it throws a CEL code for low voltage. The wideband does do a heat cycle before it starts to read is there and way to correct this so the CEL does not go on every time I start the car? Quote Link to comment Share on other sites More sharing options...
Simon Posted November 4, 2019 Report Share Posted November 4, 2019 You will have to move the fault voltage as it will be reading full scale at start up. Set error Low to 0V Bculp7 1 Quote Link to comment Share on other sites More sharing options...
shrug Posted November 4, 2019 Report Share Posted November 4, 2019 As above, set high error to 5v and low error to 0v only way I’ve been able to combat the error from aem / innovate gauges. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.