Jump to content
sh4d0w

injector pulse width g4

Recommended Posts

Hi I just installed 1200cc injectors I had 850cc injectors before. I changed my master fuel to 8ms it was 9ms before. The minimum pulse width for the new injectors is 1.8ms and I think this is causing a lean condition when at cruise because the actual pulse width is falling below the 1.8ms. 

My questions is how do I set a minimum pulse width in link g4? I see forum posts about how to set it with a g4+ but i can't find anything about the g4. Can anyone help me out please?

Not sure how to get the injector pulse width to never fall below 1.8ms

 

Thanks in advance for any help!

Share this post


Link to post
Share on other sites

There is no such feature in the G4.  Assuming the AFR is running close to target under most other conditions then you will just have to adjust the cells in the main fuel table in the high vacuum/cruise areas.

Share this post


Link to post
Share on other sites

Thanks adam,

O.k so what if it's not? At idle i need to have the car running at like 12 afr for it to run properly. What is the best solution for this? I was thinking of lowering my fuel pressure to 30 psi instead of the current ~40psi. This would bring the injectors down to like 1000cc instead of 1200cc would this help? 

Regards,

Share this post


Link to post
Share on other sites

If thats what AFR your engine needs to idle happy then so be it, run it at that.  It is more likely a poor spray pattern problem than anything PW related since they will be a decapped injector.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...