VtrSp1 Posted December 15, 2019 Report Share Posted December 15, 2019 i have a Mitusibishi Lancer Evo9 with the PlugIn ecu and a Aim MXS Strada Dash installed, but i can't see any data to the Aim Dashboard. The Aim Can wire is connect to Can1, i have check Can High- Can Low wiring and it's ok. My Aim Ecu Stream is set to LINK-CAN_BUS_BASE_LCC and the setting on the Link Ecu CAN Setup is in the picture attached . I take a look at the runtime value for the CAN1 and i see a error, in the picture attached can you see the Runtime Error for the Can1. I have switch the can connector to CAN2 , setting them proper and the error appear in the Can2 Can you help me? Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 16, 2019 Report Share Posted December 16, 2019 Both your ecu and dash config look correct. The error indicates the ecu is not receiving an acknowledgement from the dash which is usually a wiring problem. Can you give us some photos of the CAN wiring. Quote Link to comment Share on other sites More sharing options...
VtrSp1 Posted December 19, 2019 Author Report Share Posted December 19, 2019 Adamw, this is some picture about the wiring from the customer car Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 19, 2019 Report Share Posted December 19, 2019 With the CANF plug connected to the ECU (power off), if you measure resistance between the white and green wires at the back of the connector do you get about 60ohms? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.