bsh Posted January 14, 2020 Report Share Posted January 14, 2020 Hi, Is there a trigger mode that suits this trigger pattern? It is a Rover with a 18-1, 18-1 tooth on the cank. Trigger sees 17-gap-17-gap pr revolution. Running with no cam sensor and distributor. I started it configured as multitooth missing and 18-1 and as a 2 cyl just to get it running and check new built engine for leaks. Runs/idles very nice, but rpm are double of the actual. I have tried all 3 Rover trigger modes I could find in software, but seems all of them need a cam sync. Thanks Quote Link to comment Share on other sites More sharing options...
Simon Posted January 14, 2020 Report Share Posted January 14, 2020 Unfortunately there is nothing existing for that. The other Rover patterns are 3 teeth missing at uneven spacing. Maybe adding a tooth back so it becomes 36-1? Quote Link to comment Share on other sites More sharing options...
bsh Posted January 15, 2020 Author Report Share Posted January 15, 2020 11 hours ago, Simon said: Unfortunately there is nothing existing for that. The other Rover patterns are 3 teeth missing at uneven spacing. Maybe adding a tooth back so it becomes 36-1? Ok. Thanks. Quote Link to comment Share on other sites More sharing options...
bsh Posted January 26, 2020 Author Report Share Posted January 26, 2020 Tooth added, and fired up. Everything seems fine:) Quote Link to comment Share on other sites More sharing options...
Simon Posted January 27, 2020 Report Share Posted January 27, 2020 Good work not an easy task adding a tooth. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.