Bananawasp Posted March 15, 2020 Report Share Posted March 15, 2020 Hi I have an link pressure sensor that I'm wanting to setup for a safety feature can someone point me in the direction of a thread to configure the link ECU I'm hoping to get rid of my factory fitted oil pressure sensor if I can use that input? Thanks Quote Link to comment Share on other sites More sharing options...
cj Posted March 21, 2020 Report Share Posted March 21, 2020 hook your sensor to any an volt thats free, configure it as oil pressure, set the calibration correctly, then one common option is to set a GP RPM limit similar to this. It effectively applies the limiter at ~2krpm if oil pressure drops below ~400kpa at high rpm, and lower values at low rpm. You need to run some logging to see what normal pressure is for your engine before deciding on the values you will use. If you only see 300kpa at high rpm then this table will just stop you ever revving it out. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.