bob.bayloun.1 Posted May 28, 2020 Report Share Posted May 28, 2020 Hey all please someone can help post an lq4 basemap so we can start to check everything is runing fine thank you Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 30, 2020 Report Share Posted May 30, 2020 Map attached. I converted this from an xtreme file so you will see a few errors if you open it up offline (like BAP etc) but it will all come right once loaded into a Monsoon. LQ4 Monsoon Start up.pclr Quote Link to comment Share on other sites More sharing options...
bob.bayloun.1 Posted June 5, 2020 Author Report Share Posted June 5, 2020 Thank you for the attached based map should i check anything before the first startup or the basemap is enough i read in help center i should check triggers calibrate map sensor and tps setup firing order this stuff thank you for your support well appreciated Quote Link to comment Share on other sites More sharing options...
bob.bayloun.1 Posted November 17, 2020 Author Report Share Posted November 17, 2020 hello @Adamw please can you help i just used the basemap on my monsoon link ecu but the injectors are not working while first startup is there anything need to check in configuration there are no fault code but the engine is not starting thank you Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 17, 2020 Report Share Posted November 17, 2020 Do you have a realistic RPM (say 150-250RPM) showing in the software when cranking? Quote Link to comment Share on other sites More sharing options...
koracing Posted November 18, 2020 Report Share Posted November 18, 2020 It might help if you attach a datalog from the software from when key is off, then while cranking, as well as the file loaded into the ecu currently. Quote Link to comment Share on other sites More sharing options...
bob.bayloun.1 Posted November 29, 2020 Author Report Share Posted November 29, 2020 the file downloaded on the ecu i figured out the trigger should be ls2 or ls7 not ls3 but i fix it another thing tps is not calibrating it shows zero from closed to open triggers are showing okay injectors are clicking should i configure the coils on basemap i just want to check if oil and water are fine so i can move the car to dayno 1916430900_LQ4MonsoonStartup.pclr Quote Link to comment Share on other sites More sharing options...
koracing Posted November 30, 2020 Report Share Posted November 30, 2020 Can you take a PC datalog of the engine while trying to start with this tune - as well as actuating the throttle and post it here as well? Quote Link to comment Share on other sites More sharing options...
bob.bayloun.1 Posted December 3, 2020 Author Report Share Posted December 3, 2020 hello @koracing hope everything is going well ill post a photo for runtime general ill post some photos if you can help thank you is there any specific tps drive by wire need to buy thank you Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 3, 2020 Report Share Posted December 3, 2020 As requested earlier, can you please do a log of it cranking. How to do a log: https://www.youtube.com/watch?v=_P1LRANeO4A Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.