ellisd1984 Posted July 3, 2020 Report Share Posted July 3, 2020 I've started setting up the fuelling on my Celicagt4 and got to the point where I wanted to turn knock control on. Tried to turn it on and it keeps saying "Disabled" in the runtime values. I've attached my map and have a video which I'll link showing the problem. Also at idle when blipping the throttle the car revs bog down, I've tried the accel enrichment but for some reason it would let me put anything above 20 Thanks in advancehttps://www.dropbox.com/s/v237aecu6ak6qvi/20200703_161002.mp4?dl=0 Quote Link to comment Share on other sites More sharing options...
Rozsko Posted July 3, 2020 Report Share Posted July 3, 2020 2 hours ago, ellisd1984 said: I've started setting up the fuelling on my Celicagt4 and got to the point where I wanted to turn knock control on. Tried to turn it on and it keeps saying "Disabled" in the runtime values. I've attached my map and have a video which I'll link showing the problem. Also at idle when blipping the throttle the car revs bog down, I've tried the accel enrichment but for some reason it would let me put anything above 20 Thanks in advancehttps://www.dropbox.com/s/v237aecu6ak6qvi/20200703_161002.mp4?dl=0 Fuel mapped in cruise and 3psi.pclx 369.44 kB · 0 downloads In the attached map the know control is set to OFF. However when you set it to Ignition cut (for example), you also need to change the Disable digital input parameter to off. Quote Link to comment Share on other sites More sharing options...
ellisd1984 Posted July 3, 2020 Author Report Share Posted July 3, 2020 Thanks for the reply I've managed to figure it out, I wasn't expecting another switch to turn it on after i'd turned it on ha ha The next problem I'm having is stumbbling from idle. The accel enrich won't go any higher than 20 and no number i put in there seems to make a differencehttps://www.dropbox.com/s/iosy8s8rhrk0uhf/Idle stumbling logged.llgx?dl=0 Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 3, 2020 Report Share Posted July 3, 2020 You have 0 in your accel cold correction table. Our default cold correction settings below. Also, I suggest you go to main fuel settings, turn asynchronous injection on and set min async PW to 0.5ms. Then you will usually need very little accel enrichment if any. Quote Link to comment Share on other sites More sharing options...
ellisd1984 Posted July 3, 2020 Author Report Share Posted July 3, 2020 Thanks, I'll give that a try and let you know how I get on Quote Link to comment Share on other sites More sharing options...
ellisd1984 Posted July 5, 2020 Author Report Share Posted July 5, 2020 It's working much better now, thanks. I still need to do some fine tuning with the decay, I'm assuming the aim is to get it back to target as quickly as possible? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.