G4X and Link Dash Stream issues

[DanielCPG]

Hey guys, Trying to setup a display in this car and I have a couple issues. 

Ethanol Doesnt read on the dash.

I also want to output the status of my Boost control switch (dig 10) to the dash and display it as either High or Low. Its a momentary switch that is set to lash in the ecu.

 

Also i wired the fuel level guage. Ive assigned it but not sure what settings to use. Its an Evo 9.

 

Just need some pointers as im real unfamiliar with the link Dash

 

thanks 

Erics Final tune.pclx Eric.zconfig

[Adamw]

Eth content and boost switch added.  

To calibrate the fuel level, go to the live measures screen and note down the mV voltage from your fuel level sensor at various known points.  You can either do two point calibration just full and empty or you can get more accurate if you want and note down mV every say 10L added.  

Then you need to go to the custom sensors screen and fill out the calibration like below.

Eric 03.zconfig EricsFinaltune New CAN.pclx

[DanielCPG]

Thanks for the reply.

Your cal worked a treat. 

My last issue is getting the wheel speed to work. I tried to copy your method but i cant seem to add anything into the Ecu stream on the Dash. .

 

Eric Tune.001.pclx

Eric222.zconfig

[Adamw]

6 hours ago, DanielCPG said:

My last issue is getting the wheel speed to work. I tried to copy your method but i cant seem to add anything into the Ecu stream on the Dash.

Why did you change it back?  I already set up wheel speed in the last file.  

[DanielCPG]

On 9/22/2020 at 12:47 AM, Adamw said:

Why did you change it back?  I already set up wheel speed in the last file.  

Whoops.... I didn't realise you had changed that.....

It looks like the base tune has the speed signal input going to GP1. I reassigned it to RR wheel and now the dash reads speed. 

Thanks again