BackyardBuild Posted August 8, 2012 Report Share Posted August 8, 2012 The manual shows how to hook up a 2 wire ISC valve (this is how I have it wired up), but when trying to configure it the software only allows 4 wire or 6 wire. What do you have to do to get the software to recognise the 2 wire solution. thanks. Quote Link to comment Share on other sites More sharing options...
lekonna Posted August 8, 2012 Report Share Posted August 8, 2012 The manual shows how to hook up a 2 wire ISC valve (this is how I have it wired up), but when trying to configure it the software only allows 4 wire or 6 wire. What do you have to do to get the software to recognise the 2 wire solution. thanks. that part of the software is bit confusing, since its the same setup for ISC stepper valve (4 or 6 wire) and the type of ISC solenoid valve that you have installed (these come in 2 or 3 wire versions) I recon the vipec checks the output type to determine which kind of valve you are using from the output type so with the 2 wire valve you can just ignore this part of the setup. it would be nice if the whole selection was grayed out in the ui to avoid confusion when there are no stepper type ISC outputs connected. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.