Jump to content
Sign in to follow this  
BackyardBuild

2 wire ISC ???

Recommended Posts

The manual shows how to hook up a 2 wire ISC valve (this is how I have it wired up), but when trying to configure it the software only allows 4 wire or 6 wire. What do you have to do to get the software to recognise the 2 wire solution. thanks.

Share this post


Link to post
Share on other sites
The manual shows how to hook up a 2 wire ISC valve (this is how I have it wired up), but when trying to configure it the software only allows 4 wire or 6 wire. What do you have to do to get the software to recognise the 2 wire solution. thanks.

that part of the software is bit confusing, since its the same setup for ISC stepper valve (4 or 6 wire) and the type of ISC solenoid valve that you have installed (these come in 2 or 3 wire versions)

I recon the vipec checks the output type to determine which kind of valve you are using from the output type so with the 2 wire valve you can just ignore this part of the setup. it would be nice if the whole selection was grayed out in the ui to avoid confusion when there are no stepper type ISC outputs connected.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...