llabmik2 Posted March 10, 2013 Report Share Posted March 10, 2013 Would it be possible to add a activation timer on the DBW maps on a future update? Would allow for different DBW maps using the clutch switch for say a launch map. Wouldn't want the second or third map coming on during shifts when the clutch gets kicked. Quote Link to comment Share on other sites More sharing options...
Scott Posted March 13, 2013 Report Share Posted March 13, 2013 Good morning, This is currently possible, but takes a little bit of work/setup/trial. I have not tested this, but these are the steps you would follow. 1. Use Virtual Auxiliary X to activate the 2nd E-throttle table 2. Setup Aux Timer Y to activate off the Digital Input you have your clutch switch connected to. Set the Polarity to 'Reset when Off' 3. Setup the Virtual Aux X as a GP Output with switch logic as 'Cond 1 ONLY' 4. Set SW Cond 1 to Timer Y > . Specify the time you would want. The way this should work is that you press the clutch in, after the amount of specified time Virtual Aux X should switch E-throttle table 2 active. When you release the clutch pedal the timer would reset, causing Virtual Aux X to turn off, causing the E-throttle table 1 to become active. If you press the clutch in for less time than the specified e-throttle map 1 would stay active. You could also add more conditions into the Virtual Auxiliary including speed, gear and TPS positions. Scott. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.