augusto Posted February 17, 2015 Report Share Posted February 17, 2015 Fuel main - vipec i V88 Min effective pulse widht - ??? ms Injector ID 1000. What would be the value. Augusto. Quote Link to comment Share on other sites More sharing options...
Dave Kriedeman Posted February 19, 2015 Report Share Posted February 19, 2015 Hi Augusto, I normally set this value to 1 mS as anything below this value of 1 mS is referred to as non linear response from the injector. Regards Dave. Quote Link to comment Share on other sites More sharing options...
Cnstman Posted June 14, 2015 Report Share Posted June 14, 2015 1ms for ID2000 as well? Quote Link to comment Share on other sites More sharing options...
sardengineering Posted June 15, 2015 Report Share Posted June 15, 2015 That's about correct. You can verify this with your nearest Injector Dynamics dealer or with either of the main offices of Injector Dynamics for that matter. However, anything under 1 ms is right around the area where the injector(s) in question will behave in a non-linear manner just as Dave indicated. What might also be of interest is the short pulse width adder, and why the fuel model needs to know what the minimum effective pulse width would be? This information helps the ECU operate the injectors under a wide range of conditions without being transparent to awkward functionality. Cheers! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.