Matt Holmes Posted September 5, 2010 Report Share Posted September 5, 2010 I have an older V3 Link G1 and I am now converting my ignition timing vales into a new computer with 12 zones instead of six. I was wondering where the numbers shown for each zone correspond to. FOr example, if the tuning module shows 30 degrees for zone 3 (80-120 kPa), do I have 30 degrees at 80 kPa, 120 kPa, or perhaps in the middle of the zone (100 kPa)? The zones are so broad that the timing values can vary quite a bit depending on how I interprett where in the zone my numbers apply to. -Matt Quote Link to comment Share on other sites More sharing options...
Simon Posted September 7, 2010 Report Share Posted September 7, 2010 The values apply to the centre of the zone. The further you move away from the zone centre the more effect the surrounding zones have. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.