Jump to content
Sign in to follow this  
Paul M

Injector Ballast

Recommended Posts

Hi,

I have a 1.8 ohm fuel injector and 16.5-16.7V battery

In the G4 installation manual it says to use a 2.2 ohm ballast resistor for injectors 0-2 ohm

I have 4 injectors and will be using 4 injector drivers

To figure out the injector current draw I did,

16.7/(1.8+2.2) = 4.175 amps

Current seems too high and the recommendation in the G4 installation manual seems to low at 2.2 ohm

What is an expectable injector driver amperage I should be aiming for?

 

Also can anyway recommend a fuel injector ballast resistor package or box - I know haltech sell one and many oem like WRX, RX7-8 and many Nissan models come with standard from factory

Anyway know what resistance they are?

 

Thanks in advance

Share this post


Link to post
Share on other sites

What's the part no. for the ballast resistor and what's the resistance?

16V lithium battery but has more than 16V when fully charged

Prefer to wiring resistor in neatly

Something like this, need to know the resistance though

http://www.ebay.com.au/itm/Nissan-22698-05U10-OEM-Injector-Drop-Resistor-Pack-RB26DETT-GTR-R32-R33-R34-/271526675938?pt=Motors_Car_Truck_Parts_Accessories&hash=item3f384045e2#ht_140wt_922

Share this post


Link to post
Share on other sites

You ideally need to know the current the injector requires to open.

Effectively the ballast is limiting the current to that required by injector.

So if the injector needs 4 amps to open the a 2.2 ohm is about right.

If it only need closer to 2 amps then a 4R7 resistor would be the right pick.

A 10 ohm ballast will be far to big and the injector would likely never open.

Share this post


Link to post
Share on other sites

Manufacturer has said that the recommended amps to open injector is 5 amps at 12volts

Do you recommend a smaller resistor to achieve the required amps, since 2.2ohm ballast resistor achieves 4.175 amps at 16.5V?

Share this post


Link to post
Share on other sites

I would go with the 2R2 50 watt resistors.

At the higher voltage this will get the injector open happy.

We can sell these if you need. Give sales a email and they can sort.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...