Rod Smart Posted August 5, 2010 Report Share Posted August 5, 2010 I'm not sure which forum to put this... Your CAN wiring, do you twist it or just run the 3 wires in the sleeve without twisting? I have previously done some work for Bosch Australia (Clayton) with their Tech department and they said all CAN wiring must be twisted. Quote Link to comment Share on other sites More sharing options...
Dtech Motorsport Posted August 5, 2010 Report Share Posted August 5, 2010 you are correct that the CAN wires have to be twisted . Note: Link has not released the can bus communication yet the CAN plug on the ecu is currently using rs232 protocol and is used only to talk to dashes that support the link rs232 data stream. Regards Dave [email protected] Quote Link to comment Share on other sites More sharing options...
Paul1436215384 Posted January 8, 2011 Report Share Posted January 8, 2011 Can you perhaps tell us when the CAN bus communication will be enabled? This will be very useful to many people. Paul Quote Link to comment Share on other sites More sharing options...
Jurgen Biggelaar Posted January 13, 2011 Report Share Posted January 13, 2011 Paul. There is not a set date for this as yet, however I can say that it probably won't be that much further away. I promise nothing, as things can go not as expected sometimes (as you would well know), but I do know it is one of the things we would like to see happening soon. Hang in there... Jurgen Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.