Brett Whinnen Posted February 8, 2009 Report Share Posted February 8, 2009 As you know the knock sensor signal comes in over B136 pin 26, however I do not see an input allocated to this pin in the manual or base supplied map. Is there anyway to do this or will I have to rewire it via the knock block and into a spare input on the expansion slot? I do have a knock block and have two knock sensors hooked up, OE to the ECU and the second sensor to the knock block / knock link. Thanks in advance. Brett Quote Link to comment Share on other sites More sharing options...
Simon Posted February 9, 2009 Report Share Posted February 9, 2009 You will need to bring it through the Knock Block as there is no hardware on the board to support knock. Simon Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.