jozef-turbojoe Posted June 11, 2010 Report Share Posted June 11, 2010 Hi ...can anyone help mi understand what im doing wrong setting up wanos. Car is wired up and running we strapped the car to dyno and begin with base map , but cam error count is large and i am bit confused coz i newer did dual vanos . I am not sure if its my settings , but i am using DI-1 for intake cam, ref and DI-2 for ex. reference and 1-4 aux.ch. diodes wore removed from vanos module , base ignition timing lock on spot follows well no problem .How do i check when cams are at 0 deg. ?? in VVT tables dos 0 value means 0 deg . and than positive # is cam advance and neg. # is retard ? Quote Link to comment Share on other sites More sharing options...
jozef-turbojoe Posted June 11, 2010 Author Report Share Posted June 11, 2010 if my map is needed i will email it so you can see what i got for settings , thanks again Quote Link to comment Share on other sites More sharing options...
jozef-turbojoe Posted June 12, 2010 Author Report Share Posted June 12, 2010 ok after feud corrections in the set up settings now im getting no error counts in cam but still got a error for a ex cam error extra pulse any ideas ?? anyone ??? Quote Link to comment Share on other sites More sharing options...
Karim-Philip Antaki Posted June 14, 2010 Report Share Posted June 14, 2010 Hello You need the following connections: \ AUX 1 VVT inlet right AUX 2 VVT inlet left AUX 3 VVT exh right AUX 4 VVT exha left DI 1 cAm pos inlet LH Trig 1 crank Trig 2 Cam Tri g 2 VVTI exh LH trig offset 270 deg... Try that KPA Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.