claudiumxg Posted August 9, 2011 Report Share Posted August 9, 2011 hello, how do i control dual wastegate solenoids on evo 9 Jdm model with plugin board? link wires on output? or separate outputs an tables? Quote Link to comment Share on other sites More sharing options...
claudiumxg Posted August 9, 2011 Author Report Share Posted August 9, 2011 ps . sorry for first post , i couldnt write with Ie8 only firefox Quote Link to comment Share on other sites More sharing options...
Dynotech NZ Posted August 10, 2011 Report Share Posted August 10, 2011 Just buy the link 3 port soleniod and wire to the active soleniod wiring (not the passive) Â Done this on my Evo 9, works perfect and I use close loop boost for accurate boost control Quote Link to comment Share on other sites More sharing options...
claudiumxg Posted August 11, 2011 Author Report Share Posted August 11, 2011 thanks, but i forgot to mention tahat is for a rally Gr.N car and i have to keep original solenoids, any ideas? Quote Link to comment Share on other sites More sharing options...
Simon Posted August 12, 2011 Report Share Posted August 12, 2011 The g4 has both solenoids paired and they operate off Aux 3 in parallel. You can then almost treat them as a single solenoid. Quote Link to comment Share on other sites More sharing options...
claudiumxg Posted August 12, 2011 Author Report Share Posted August 12, 2011 thank you for your answer, so there is no need to link wires or anything eles, just plugi in and control both with same table Quote Link to comment Share on other sites More sharing options...
Simon Posted August 14, 2011 Report Share Posted August 14, 2011 Yep. It wont be as good as a 3 port solenoid but for group N you don't get much choice. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.