Jump to content
Sign in to follow this  
Sebastian Larsson

Subaru WRX Plugin (v7-v9) vvt problems

Recommended Posts

Hi Sebastian.

You first need to confirm the wires are going to the correct place on your pin out.  Then to double check your settings in line with what the manual/help file says.  If you attach a copy of the map I can see if there is anything obvious that may be not set correctly.  

This is most likely how your set up should look on those DI's...

http://i903.photobucket.com/albums/ac236/linkelectro/camcontrol.jpg

 

Jurgen

Share this post


Link to post
Share on other sites

Hello!

 

I have look in the wiring diagrams but i only find the cam position sensor to trigger2 on left intake camshaft, im not find any cam solenoids in the wiring diagram how it works? and one more question the TGV valve i dont need to use it? is it 100% open when no power to it?

 

MVH Sebastian Larsson

Share this post


Link to post
Share on other sites

Attached is the corrected pcl file for the Subaru v7.

Changes included:

DI 2 pullup resistor changed from on to off
Active edge changed from rising to falling
Aux output 2 changed from /LH inlet to RH inlet

 

With these changes the map works on the bench.

You will need to check in the run times display (F12) under the VVT tab for more info on what the cam triggers are doing.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...