Jump to content

A couple small issues.


Guest Marcel B

Recommended Posts

Guest Marcel B

Well today I finally passed a mile stone :D I got to a point in my install where I was able to power up the ECU and do a bit of configuring . One of the main problems I encountered was the setting of the injector outputs .I plan on using the SEQUENTIAL / STAGED mode , having two primary injectors (1&2) and four secondarys (5-8) .For outputs 1-4 I have no access , I cannot get in to select injection or anything else , and for 5-8 when I select injection , it switched back to "not selected" on its own :!:

Also , what kind of sensor should I select for the IAT ? When the standard bosch was selected it read -20 deg on a 35 deg day , I went through the whole list and selected the one that seemed the most likely as it read 20 deg , but of course I am not sure it is correct . ray can you help ?

Link to comment
Share on other sites

Marcel,

I will email you a base map from the Series 6 RX7 with staged injectors, to look at. This is from a tuned car. It had 500cc primary and 1600cc secondary.

Select a table as the sensor type, and fill out the table like this.

VipecAirTempScale.jpg

Also if you have not upgraded to firmware version 4.2.0 then do this.

Ray.

Link to comment
Share on other sites

Guest Marcel B

OK ray I will look out for the e mail and set op the sensor like you said .

IAT sensor come with ecu is KTY83? That's what set in my v88.

yep , thats the one I selected , but it reads 10 degrees less than the ECT sensor which is reading air temp right now (now water in the motor yet).

Link to comment
Share on other sites

Guest Marcel B
Do as Ray wrote, don't select anything.

Vipec sensor is accurate.

I set up the cal table as ray said and its perfect now . I am also using a pair of AIM tem. sensors for oil and fuel temp measurement , but I cant seem to find any info on them except that they read from 0-150 deg. C , can anyone help ? I need to set up a cal table for them too , this is what they look like

61a0_1.jpg

Any information would be greatly appreciated.

Link to comment
Share on other sites

  • 3 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...