David Frechette Posted November 11, 2014 Report Share Posted November 11, 2014 Are all G1 LEM V5's PC compatible or does it need to have a certain firmware version. Â If so could you tell which versions are PC compatible and which ones are not. Â I have the hand held tuning module and check quickly. Â Thank you. Â Quote Link to comment Share on other sites More sharing options...
Simon Posted November 12, 2014 Report Share Posted November 12, 2014 V5 is the firmware version so yes all V5's are PC compatible. V4 is also but pre V4 is not Quote Link to comment Share on other sites More sharing options...
David Frechette Posted December 23, 2014 Author Report Share Posted December 23, 2014 Thanks, I just received my PC link a couple of weeks ago.  Still many days of motor work before I can fire and tune.  I need to get a PIN connector, my 17 pin head connector is missing the NBOxy white wire and also I would like to get the 4 pin aux connector.  Can I purchase those direct or could you recommend a US dealer in Ca.  Thanks  Quote Link to comment Share on other sites More sharing options...
Simon Posted January 14, 2015 Report Share Posted January 14, 2015 What com port number is being assigned to the adapter? It will need to be lower than com 10. Quote Link to comment Share on other sites More sharing options...
Simon Posted January 14, 2015 Report Share Posted January 14, 2015 What com port number is being assigned to the adapter? It will need to be lower than com 10. Make sure you are using the correct PC link version should be version V2.5 Quote Link to comment Share on other sites More sharing options...
David Frechette Posted January 14, 2015 Author Report Share Posted January 14, 2015 PC COMM Port 3 or 4 are my USB 3.0 ports. Â I have been trying both. Â PC Link is V5.2.2.2245, where do I find PC Link V2.5? Â Quote Link to comment Share on other sites More sharing options...
David Frechette Posted January 14, 2015 Author Report Share Posted January 14, 2015 Found IT! Â Ok, so I dumped PC link V5, found V2.5 and installed. Â Went to options under connections and set it to COM 3. Â In the device manger for COM 3 I set everything to default which are the following. Bits Per Second: 9600, DATA Bit: 8, PARITY BIT: None, STOP BIT: 1, FLOW CONTROL: None Under the Advanced Tab the FIFO Box is selected and the receive and transmit speeds are defaulted. Â Still cannot connect. Â Quote Link to comment Share on other sites More sharing options...
David Frechette Posted January 14, 2015 Author Report Share Posted January 14, 2015 Never mind Simon, I'm in.  Thanks for your help. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.