Guest |172| Posted November 3, 2008 Report Share Posted November 3, 2008 Ray, does the V88 with the Nissan adaptor have the correct voltage output pin for the operation of the ATTESSA 4WD ecu? Paul Quote Link to comment Share on other sites More sharing options...
rayhall Posted November 4, 2008 Report Share Posted November 4, 2008 Paul, The adaptor has a small circuit that allows the TPS signal to be shared with the 4WD controller. Ray. Quote Link to comment Share on other sites More sharing options...
Guest |172| Posted February 11, 2009 Report Share Posted February 11, 2009 Ray, the car is up and running but i have no 4WD...what can i check? Does the adaptor need a jumper link to activate this feature? The board currently has no jumpers fitted. Quote Link to comment Share on other sites More sharing options...
rayhall Posted February 11, 2009 Report Share Posted February 11, 2009 Paul, There are no jumpers involved. Pin 56 on the Nissan connector is the TPS signal to the 4WD controller. There are no other signals required or used. Check this pin has the same voltage as the TPS input signal (pin 38) as you open and close the throttle. Quote Link to comment Share on other sites More sharing options...
Guest |239| Posted February 11, 2009 Report Share Posted February 11, 2009 cheque the attesa computer in the boot, and read how many flashes are coming form the unit, that will tell you exactly what cable is missing on the wiring on the side of the car were the ecu is, the only plug that has 1 cable (single 1) is the cable that goes from ecu tps output to attessa ecu in the boot Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.