JonoP Posted October 10, 2014 Report Share Posted October 10, 2014 Hi, I have just purchased one of these ALM-CAN wideband units because it uses the newer, faster, and longer duty cycle Bosch sensor (4.9LSU) Here is a link to the Unit: http://www.ecotrons.com/products/wideband-controller-alm-can/ Here is a link to its manual containing the CAN BUS setup: http://www.ecotrons.com/files/ALM-CAN%20Manual.pdf It goes into great detail about all of the data bits etc. I don't even know where to start when configuring it though. Is it possible I get some help? Maybe configure a PCL file for me and post it so that I can copy the settings into mine? I hope I am not asking for too much. Thanks  Quote Link to comment Share on other sites More sharing options...
JonoP Posted October 11, 2014 Author Report Share Posted October 11, 2014 I email ALM and they sent me this, which looks exactly like the data we need to configure the CAN bus. Maybe once sorted we can make a .lcs stream file? Â Quote Link to comment Share on other sites More sharing options...
Simon Posted October 13, 2014 Report Share Posted October 13, 2014 Hi. We can make this unit work but currently it is not supported. We would really need to have a unit to test and confirm the required stream. Quote Link to comment Share on other sites More sharing options...
JonoP Posted October 13, 2014 Author Report Share Posted October 13, 2014 Is there anything that I can do? I have a new unit here, and wanted to connect it via the CAN Bus. Are you able to "guess" the settings with the information that I Have given you? Quote Link to comment Share on other sites More sharing options...
Simon Posted October 14, 2014 Report Share Posted October 14, 2014 Are you in NZ? If so sending the unit in would work the best. Quote Link to comment Share on other sites More sharing options...
JonoP Posted October 14, 2014 Author Report Share Posted October 14, 2014 Sorry - in Australia. Sending the unit could be possible though. Quote Link to comment Share on other sites More sharing options...
Simon Posted October 15, 2014 Report Share Posted October 15, 2014 We have a got one of the engineers to sit down and nut out what the stream should be. You will need to change the Can setup to match attached image. Then load the attached stream file into stream 1 Â Quote Link to comment Share on other sites More sharing options...
JonoP Posted October 15, 2014 Author Report Share Posted October 15, 2014 Wow... thanks guys! I will check it out and see if I can get it working with those settings. Your support is fantastic. Quote Link to comment Share on other sites More sharing options...
dmacnz Posted October 17, 2014 Report Share Posted October 17, 2014 Any update on Closed loop fuel via CAN bus yet? Still hoping to get this bug fixed asap!! CAN bus is the future! Quote Link to comment Share on other sites More sharing options...
Simon Posted October 20, 2014 Report Share Posted October 20, 2014 Currently it is fixed in our test firmware. Quote Link to comment Share on other sites More sharing options...
dmacnz Posted October 26, 2014 Report Share Posted October 26, 2014 Fantastic! Looking forward to that! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.