Jump to content

Car dont start


Thomas Pyk

Recommended Posts

It is Volvo B230 turbo installed a link G4 storm.Engine running good.Starts good.Suddenly it is hard too start enginge. Still runnig good when hot.Stops the engine.It couldnt start.Checked sparks when cranking OK.Cranking a few times the plugs was not wet. Made a injector test working fine.Engine started after the test.Looks it get fuel under injector test but not under start up procedure.It goes very under idle.Is it some problem with my ECU or what could it be?

Link to comment
Share on other sites

Trigger setup crank Missing teeth 2 Tooth count 60 Trigger mode multitooth/missing Syncpulse no Sync level no trigger priority trig 1.Trigger 1 type reluctor Trigger 1 filtering level 1(low) Trigger 1 arming threshold engine speed (RPM) 0 1000 2000 3000 4000 5000 6000 7000 0.5* 1.0 1.5 2.0 3.0 3.5 3.5 3.5 Calibriate ref timing. 10.0 trigger offset. 92 lock to ref. Off Trigger 2 (NOT USED) Trigger 2 filtering level 2 Trigger arming threshold engine speed (RPM) 0 1000 2000 3000 4000 5000 6000 7000 0.5* 1.0 1.5 2.0 3.0 4.0 4.0 4.0

Link to comment
Share on other sites

Is the ECT reading correctly?  Is the post start fueling set up correctly?  If it suddenly stopped starting then chances are the problem is a sensor failure or bad wiring connection.  Otherwise maybe the temperatures got colder and it wasn't tuned in those areas???

Link to comment
Share on other sites

I got a hint from my dealer, check up trigger signal and cranking speed and found starter motor was worn out,field windings was damage and when starting power was low too electric circuit it could not start, sometimes it started.A new starter motor was installed.The car starts easily now and runs good,even better now.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...