Jump to content
Sign in to follow this  
John Smith

No Idle Ignition Table on R34GTT?

Recommended Posts

Howdy,

I have an R34GTT plug and play G4. I have just done an inlet and throttlebody conversion to fit an RB26 6x throttlebody setup. I have pulled across the RB26 ACV as well but I can't seem to find a way to enable to the idle ignition control selection under ECU Settings (as available on the RB26 base map) on my R34GTT map. 

I'm assuming that there is a setting somewhere that will enable it, but i can't find it for the life of me. When I search under parameters it does show the field but it's greyed out.

At the moment it's idling at almost 1800 rpm and i need to lower it down.


Thanks 

Share this post


Link to post
Share on other sites

You will need to get the idle a bit lower before the ignition trim will be effective.

Check you have current firmware in the ECU and have not used up all available tables.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...