Anthony Parle Posted December 23, 2013 Report Share Posted December 23, 2013 In the set up PDF it mentions on page 70 to set the fuel Table Load Axis I can select either, MAP or MGP or TPS. for what ever reason the options are only MAP or BAP or BAP/MAP So what do I need to do to get TPS to be on the load table for fuel? Tony Quote Link to comment Share on other sites More sharing options...
Dynotech NZ Posted December 23, 2013 Report Share Posted December 23, 2013 Got to your fuel table Right click the load axis Select axis setup Under Y axis select 'TPS main' Push init axis button Push Apply button Done Quote Link to comment Share on other sites More sharing options...
Anthony Parle Posted December 23, 2013 Author Report Share Posted December 23, 2013 Phil Worked perfectly, if you were here I would buy you a beer, I am new to programing ECU's so I feel a bit lost in the woods at this point. The project may cause my hair to fall out. Always learning new program is the worst thing possiable. Tony  Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.