Jump to content
Sign in to follow this  
andy tappenden

Bmw 328 triggers on 325 link?

Recommended Posts

Hello all

 

ive recently fitted a link g4 to a customers 328 E36

i have ect/tps/map/iat etc working but cant get rpm signal

as far as i can see on the diagrams the 325(m50 with bosch ecu)

uses vr(inductive/normal)crank sensors

however the 328(m52 with siemens) seem to use some hybrid hall/vr 5v sensor

i have tried all sorts to get it running in trigger settings but no rpm signal(car ran on stock ms41 m52 ecu)

from what i can make out according to bmw and autodata i have

red/yellow 5v live

yellow signal wire

and a brown -ve

any body come across this before?

am i better off fitting a m50/325 vr sensor?

thanks

Please help

andy


Share this post


Link to post
Share on other sites

Hi Andy

Some BMW sensor had a signal applied to them and the ECU monitored the change as teeth went past.

If you can not get an RPM reading by changing the trigger settings to trigger 1 sensor type opto/hall and pullup turned on.

Then swapping to the M50 sensor will be the go.

Share this post


Link to post
Share on other sites

Right fitted m50 (inductive) 325 crank sensor.

wired brown trigger +ve.       Pin 1

yellow -ve(sensor ground).    Pin2

red yellow shield(shield ground). Pin 3

set reluctor in trigger 1 

60-2

level low.

 

still no rpm swapped +ve and -ve nothing

did have trigger yes on signal once but no rpm

have 2-3 volts ac across brown and yellow whilst cranking

It did seem odd though that when i connect -ve wire to ecu sig ground i lose the 2-3 volt ac

 

please help

 

thanks

 

andy

Share this post


Link to post
Share on other sites

If you are running just the crank trigger and are not using a CAM sync then make sure in the trigger 2 menu the sync mode is set to None.

Share this post


Link to post
Share on other sites

Right by fitting m50 crank sensor (sync off) i have rpm

i need to get the cam working though for Sequential

ive fitted a m50 cam sensor but have no voltage or signal.

is there a possibility the cams have a different trigger Wheel

 

ive even wired the crank into trig 2 and have signal yes to test circuit.

 

thanks

 

andy

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...