Lawrence martin Posted September 8, 2011 Report Share Posted September 8, 2011 hi i have setup my fueling so 3rd is 11.4 to 11.8 afr but if i log 1st gear pulls it registers as 13.4 2nd gear registers as 12.4 is this a problem? i understand that the engine is reving quicker and there is more load on the engine in 1st but the mgp stays roughly the same (within a few points) shall i run into the 10's in 3rd to richen up 1st or is there a better way if this is a problem? Quote Link to comment Share on other sites More sharing options...
Phil Williams Posted September 12, 2011 Report Share Posted September 12, 2011 Hi Lawrence, This does occur on some setups, some more so than others. Try spanning a 4d fuel table of the 'RPM Rate' parameter and use this to correct for the error. Any other suggestions are welcome. Regards, Phil Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.