Jump to content
Sign in to follow this  
pawan jupiter

link g4 p&p v4 wrx trigger errors

Recommended Posts

hey guys i got a link g4 p&p plugged it in and setup all the sensors as the manual said. i used the map sensor option of a v7/8 option since it was the closest to the barometric sensor reading since the v3/4 option was way off to about 78kpa where the barometric read 101kpa .  the car would not start but the car cranked over at a good speed.  when going through the software and looking at the trigger status it said no trigger 1 signal ,trigger 2 signal, no eccs signal and the trigger 1 error count was 65.  the trigger 1 arming voltage was 0.50v and trigger 2 was 0.48. the rpm limit data was 5000 and the map limit was 180 kpa.

 

any ideas to how i rectify this error and get my car running haha.

Share this post


Link to post
Share on other sites

Hi

 

I had the same problem in my MY97GT. Have you checked, that the crank trigger is trigger 1 and the cam sensor trigger 2 is?

That was the mainproblem in my car. The 2nd was the Trigger position. The best reason is to control the TDC mark with a timing light. On my Engine the Camwheel trigger is 180° offset

 

Greats

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...