Guest |305| Posted April 23, 2009 Report Share Posted April 23, 2009 hey ray, this is richard from chicago usa....i had a couple of questions about the external map sensor install is there a way i could install it in the imput channels that are not being used.......and also about the lambda sensor could i install in the channels of the oxygen sensor and still read quicktune setting and apply the boost comp table.....and could i install it straight to the ecu as a signal of 0-5volts input and where to put it..... i have the s14/s15 ecu Thanks Richard Quote Link to comment Share on other sites More sharing options...
rayhall Posted April 23, 2009 Report Share Posted April 23, 2009 Richard, External map sensor can be connected to any volt input. There are some on the expansion connector. Also the +5v supply and Sensor GND. A signal from a wideband meter can be connected to the stock 02 sensor input. Then select Wideband. I am not clear on the question of the boost compensation. Are you saying you want to vary the boost based on air fuel ratio ? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.