Janko_D Posted August 25, 2015 Report Share Posted August 25, 2015 Hallo, I can't set up my knock control. Does my G4+ Storm Ecu (Serial 23058) have a knock control on DI3? On DI5 I have Ethanol sensor and I can't turn it off. Quote Link to comment Share on other sites More sharing options...
bsh Posted August 26, 2015 Report Share Posted August 26, 2015 For the knock you wire direct to Di3 pin and then select internal digital knock.Make sure the Di3 function has been set to off. Quote Link to comment Share on other sites More sharing options...
Janko_D Posted August 26, 2015 Author Report Share Posted August 26, 2015 DI3 function is off. Knock mode is ON Knk Internal. I want to wire the knock sensor direct to DI3, Is my Storm Ecu with internal built in knock control hardware? Quote Link to comment Share on other sites More sharing options...
Dave Kriedeman Posted August 26, 2015 Report Share Posted August 26, 2015 (edited) Hi Janko_D,Please find attached a screen shot of the correct setup.PLEASE NOTE ::::: THE PULLUP RESISTOR MUST BE SET TO OFF or KNOCK CONTROL WILL BE FORCED OFF.RegardsDave. Edited August 27, 2015 by Dave Kriedeman Quote Link to comment Share on other sites More sharing options...
Janko_D Posted August 27, 2015 Author Report Share Posted August 27, 2015 Hi Janko_D,Please find attached a screen shot of the correct setup.PLEASE NOTE ::::: THE PULLUP RESISTOR MUST BE SET TO OFF or KNOCK CONTROL WILL BE FORCED OFF.RegardsDave.Hi Dave,Which pullup resistor, the one on DI3? I can't see the screen shot, would you sent it at [email protected]Regards,Janko Quote Link to comment Share on other sites More sharing options...
Dave Kriedeman Posted August 27, 2015 Report Share Posted August 27, 2015 (edited) Hi Danko,Sorry previous information I supplied was incorrect I had the setup for external Knock device.So DI 3 is to be left turned off and just activate Knock Control as on, Internal Knock, the knock sensor signal wire must go to DI3.RegardsDave. Edited August 27, 2015 by Dave Kriedeman Corrected info. Quote Link to comment Share on other sites More sharing options...
Janko_D Posted August 27, 2015 Author Report Share Posted August 27, 2015 Thank you, Dave Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.